User Manual
4 D-303370 CLIP PG2 Installation Instructions
AA
A. Window
Note: The CLIP PG2 can be mounted on either side of a window.
Figure 14. Mounting on Both Sides of a Window
2.4 Setting the Coverage Range
The CLIP PG2 can be programmed to select one of three ranges,
according to the type of installation, for the curtain beams (see
Figure 15 and section 2.7).
A. Minimum range
B. Medium range
C. Maximum range
Figure 15. Range Setting Diagram
2.5 Walk Testing
A. Mount the cover and tighten the screw. Wait for the detector to stabilize (the LED stops flashing approx. 1 minute after the cover is closed).
B. Walk slowly across the far end of the curtain pattern (in opposite directions). The LED indicator lights for approx. 3 seconds whenever
you enter or exit a curtain beam.
Important: Perform walk test at least once a week to assure proper function of the detector.
Note: After closing the cover the detector enters a 15 minute walk-test mode. In this mode the LED will flash each time a detection
occurs, regardless of LED jumper settings, and the detector will transmit on the occurrence of each detection event.
2.6. Enrollment
Refer to the PowerMaster panel's Installer Guide and follow the procedure under the "02:ZONES/DEVICES" option of the Installer Menu.
A general description of the procedure is provided in the following flow chart.
Step 1 Step 2 Step 3 Step 4 Step 5 Step 6
Enter the Installer menu
and select
“02:ZONES/DEVICES”
Select "ADD NEW
DEVICES" Option
See Note [1]
Enroll the device or Enter
the device ID
Select the desired Zone
Number
Configure Location,
Zone Type &
Chime Parameters
Configure
the
Detector
means scroll
and select
See Note
[2]
Notes:
[1] If the detector is already enrolled you can configure the detector parameters via the “Modify Devices” option – see Step 2.
[2] Select the "Device Settings" option and refer to section 2.7 to configure the detector parameters.
2.7. Configuring the Detector Parameters
Enter the menu and follow the configuration instructions for the CLIP PG2 curtain detector as described in the following table.
Option Configuration Instructions
Define whether or not the alarm LED indication will be activated.
Optional settings: LED ON (default) and LED OFF.
•
•
Select one of three ranges, according to the type of installation, for the curtain beams. Select "Maximum" for a
range of 6 m, select "
Medium
" for a range of 4 m, or select
"Minimum"
for a range of 2 m.
Optional settings: Maximum (default), Medium and Minimum.
•
•
Define whether or not to set the activity time during disarm
.
Optional settings: NOT Active (default),
YES – no delay
,
YES + 5s delay
,
YES + 15s delay, YES + 30s delay, YES + 1m
delay, YES + 2m delay,
YES + 5m delay, YES + 10m delay, YES + 20m delay
and
YES + 60m delay
.
•
•
DISARM Activity
PIR RANGE
Alarm LED
DEVICE SETTINGS
Z03.DEV SETTINGS
Z03.SET CHIME
Z03.ZONE TYPE
Z03.LOCATION
ID No. 122-XXXX
Z03:Motion Sens
ENTR ID:XXX-XXXX
ENROLL NOW or
MODIFY DEVICES
ADD NEW DEVICES
02.ZONES/DEVICES