Installation and Operating Instructions

Regulatory Information
The device HTD-432 PG2 has a recommended service life of 10 years under normal conditions of use.
Please refer to the label applied to the device indicating the recommended replacement year.
This manual shall be used in conjunction with the Installation Manual of the alarm control panel. All the
instructions specified within that manual must be observed.
Frequency band Maximum power
868.0 MHz - 868.6 MHz 14 mW / 11.46 dBm
868.7 MHz - 869.2 MHz 14 mW / 11.46 dBm
912 MHz – 919 MHz 14 mW / 11.46 dBm
Hereby, Visonic Ltd. declares that the radio equipment type HTD-432 PG2 is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following
internet address: http://www.visonic.com/download-center.
Regulatory Listings: UL521/ULC-S531 for HTD-432 ME PG2.
The HTD-432 ME PG2 has been listed by UL/ULC for residential fire applications in accordance with
the requirements in the Standard UL985/ULC-S545, when used in conjunction with compatible
panels identified in this manual.
The HTD-432 ME PG2 has been listed by UL for residential fire applications in accordance with
the requirements in the Standard UL985, when used in conjunction with compatible panel Qolsys
IQPanel2 ME. The HTD-432 PG2 has been listed by UL for residential fire applications in
accordance with
the requirements in the Standard UL985, when used in conjunction with compatible panel Qolsys
IQPanel2 ME.
FCC MODIFICATION STATEMENT
Visonic Ltd. has not approved any changes or modifications to this device by the user. Any
changes or modifications could void the user’s authority to operate the equipment. Visonic Ltd.
n’approuve aucune modification apportée à l’appareil par l’utilisateur, quelle qu’en soit la
nature. Tout changement ou modification peuvent annuler le droit d’utilisation de l’appareil par
l’utilisateur.
FCC AND ISED CANADA INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device. This
device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'ISED Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radio électrique subi, même si le brouillage est susceptible d'en comprom-ettre le
fonctionnement.
FCC CLASS B DIGITAL DEVICE NOTICE -This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or experienced radio/television technician for help.
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company
from which you originally purchased it. If you are discarding this product and not
returning it for repair then you must ensure that it is returned as identified by your
supplier. This product is not to be thrown away with everyday waste. Directive
2012/19/EC Waste Electrical and Electronic Equipment.
© 2021 Johnson Controls. All rights reserved. JOHNSON CONTROLS is a registered
trademark. Unauthorized use is strictly prohibited.
D-308432 HTD-432/HTD-432 ME PG2 Wireless Heat Detector Rev. 0 (08/21)
EMAIL: [e-mail]
Website: www.visonic.com