User's Manual

6. System Configuration
30 D-304269 KP-250 PG2 User’s Guide
6.
To delete the tag press the button.
DELETE
TAG
A "Happy Tune" ☺ sounds and the display reads [ DELETE TAG ] and returns to
step 3.
11
☺ Go to step 3
Additional Information (section B.6)
1
For detailed instructions on how to select User Settings – refer to section A.1 and section A.2.
2
The display shows the first enrolled Tag (Tag No.1) of the 8 (PowerMaster-10 G2) / 32 (PowerMaster-30 G2 /
PowerMaster-33 G2) tags.
3
To abort enrollment, press the button.
4
If the tag was previously enrolled in the system, the KP-250 PG2 display indicates this together with the tag's ID
number, for example, "ALREADY ENROLLED T01:Tag (Prox)".
5
If Partition is enabled, continue to step 6.
6
You can now enroll another proximity tag. You can also select another option in the User Settings menu (see
section A.1 and section A.2), or quit programming (see section A.3).
7
If no proximity tag is enrolled in the system, the display reads [ NO EXISTING DEV. ].
8
To abort the procedure, press the button.
9
This setting can be performed only after completing steps 1 - 5 of section B.6A.
10
You can now repeat steps 2 - 7 to program or edit another Proximity tag.
11
You can now add or delete another proximity tag. You can also select another option in the User Settings menu
(see section A.1 and section A.2), or quit programming (see section A.3).
B.7 Add / Delete Keyfob Transmitters
Each of the 8 (PowerMaster-10 G2) / 32 (PowerMaster-30 G2 / PowerMaster-33 G2) users may be provided with a
portable keyfob transmitter for better, quicker and safer arming/disarming and other control functions. Each keyfob
should be assigned with a serial No. 1-8 (PowerMaster-10 G2) / 1-32 (PowerMaster-30 G2 / PowerMaster-33 G2) and
enrolled into the system correspondingly.
Partition Option (For information about Partition option - see APPENDIX B).
If the Partition option is enabled in the KP-250 PG2, each of the 8 (PowerMaster-10 G2) / 32 (PowerMaster-30 G2 /
PowerMaster-33 G2) keyfobs can be authorized by the Master User to arm and disarm any combination, or all 3
partitions, irrespective of the authorization of its corresponding user code.
 Here you can add (enroll) the 8 (PowerMaster-10 G2) / 32 (PowerMaster-30 G2 / PowerMaster-33 G2) Keyfob
transmitters and define which of the 3 partitions each of the keyfob will be authorized to arm and disarm, or delete
keyfobs as required.

1. Before anything else, gather up all keyfob units you intend to enroll and make sure they all have batteries
installed and that they are active (the LED blinks upon pressing any of the buttons).
2. Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see table
at end of this section.