User guide
APPENDICES 
38  D-303984 PowerMaxComplete User's Guide 
Siren
A partition is alarmed when receiving an event from 
an  alarmed  device  assigned  to  that  partition. 
Alarmed devices  do not  affect partitions  to which 
they are  not  assigned.  A  siren  is  common  to  all 
partitions;  therefore,  an  alarm  from  one  or  more 
partitions will activate the siren. 
Siren Activity 
  The  siren  will  be  activated  when  receiving  an 
event from an alarmed device. 
  Overlapping  siren  activations  from  different 
partitions will not cause the duration of the siren 
to be extended. 
  When the siren sounds, it will not stop until all 
alarmed partitions are disarmed. However if the 
siren is active due to an alarm from a common 
area zone, and one of the partitions assigned to 
this area disarms the system, the siren will also 
stop. In  case that the  alarm is initiated  from a 
common area but continues with zones that are 
not assigned to  a common area, the  siren will 
not  stop  until  all  partitions  assigned  to  the 
alarmed zones are disarmed. 
  In case that there is a fire in partition 1 and a 
burglary in partition 2, the siren will sound FIRE. 
When  partition  1  is  disarmed  the  siren  will 
sound BURGLAR for the remainder of the siren 
timeout period. 
Partition Status display 
Partitions status is indicated in the following manner: 
P1:X P2:X P3:X 
Each X value indicates a different partition state, as follows: 
R 
Ready 
N 
Not ready 
A 
Away 
H 
Home 
E 
Exit delay 
D 
Entry delay 
- 
Not used 
MCT-237
The MCT-237 two-way wireless keyfob is  used to 
control single or all partitions. 
Arming/Disarming All Partitions 
To  arm/disarm  all  partitions,  press  the  HOME  / 
AWAY / DISARM button on the keyfob. 
Arming/Disarming a Single Partition 
To  arm/disarm  a  single  partition,  press  the 
PARTITION SELECTION button on the keyfob once. 
In this  state repeated  pressing of  the  PARTITION 
SELECTION button will toggle between the enabled 
partitions and Partition All. To arm/disarm the desired 
partition(s), press the HOME/AWAY/DISARM button. 
MCT-237 
DISPLAY
DISARM
PARTITION
SELECTION
AUX 2
AUX 1
HOME
AWAY










