Manualshelf

User's Manual

ManualsBrandsVisonic ManualsElectronicsPanic button keyfob
1234
D-304457 PB-101/102 User’s Guide 1
PB
PBPB
PB-
--
-101
101101
101
PG2 /
PG2 / PG2 /
PG2 /
PB
PBPB
PB-
--
-102
102102
102
PG2
PG2PG2
PG2
Wireless Panic Button
Installation Instructions
1. INTRODUCTION
1. INTRODUCTION1. INTRODUCTION
1. INTRODUCTION
The PB-101 PG2 and PB-102 PG2 are miniature PowerG
pendants, designed for use with PowerMaster control panels and
other PowerG receivers.
To activate transmission, press the pushbutton(s) at the center of
the unit. When activated, the transmitter sends out an alarm code,
and a buzzer sound and the LED light indicates confirmation about
successful or failed transmission.
The PB-101/102 has several options for carrying or mounting it.
The unit is supplied with a belt clip, a key chain, a lanyard
necklace, and a holder which can be attached to the belt clip or
mounted on a wall.
Figure 1. PB-101 and PB-102
2.
2. 2.
2. OPERATION
OPERATIONOPERATION
OPERATION
The following functions are available:
Function
PB
-
101
PB
-
102
Panic
The signal will notify
your central monitoring
station of an emergency
situation.
Press and hold the button down for
2 – 7 seconds.
Press and hold both buttons down
simultaneously for more than 3
seconds.
No activity
utton press is ignored.
Press and release the button in less
than 2 seconds.
---
Not applicable
Arm
Arm your system in the
Away mode.
---
Not applicable
Press and hold this button for less than
7 seconds.
Disarm
Disarm your syst
em.
---
Not applicable
Press and hold this button for less than
7 seconds.
3. ASSEMBLY FOR
3. ASSEMBLY FOR 3. ASSEMBLY FOR
3. ASSEMBLY FOR PORTABILITY AND
PORTABILITY AND PORTABILITY AND
PORTABILITY AND MOUNTING
MOUNTINGMOUNTING
MOUNTING
This section describes how to attach the PB-101/102 to various portability options.
WARNING! Choking Hazard; Small parts; The pendant and belt clip are NOT for children under 3 years.
Figure 2 Attaching PB-101/102 to a Belt Clip
1. Slide the PB-101/102 into the holder until you feel it snap securely
inside.
2. To attach the belt clip, slide it onto the rails on the rear of the
holder.
3. To remove the PB-101/102 from the wall-mounted holder or from
the belt clip, press down the top of the holder and push the pendant
up with your fingers.
Figure 3 Attaching PB-101/102 to a Key Chain
Figure 4 Attaching PB-101/102 to a Lanyard Necklace

Summary of content (4 pages)