User guide

Chapter 6: Data Details Tables
DE5450S Remote Programmer Guide Rev. 9 29
6.3 User Codes
This table defines the PowerMax/PowerMaster users and lists their codes. Only
users, whose numbers and codes are listed in this screen, can activate the control
panel. PowerMax and PowerMaster-10 can store up to 8 user numbers and codes.
PowerMaster-30 can store up to 48 user numbers and codes. All User codes must
be different from the Duress code and Installation code.
User Number 1 is known as the Master User. He is the only user who has the
authority to modify the User Settings and User Codes screens. The Master User
code cannot be 0000.
To Enter a User Code
1. Identify the user number you wish to define.
2. Enter a four-digit code that is unique to the selected user number.
3. Enter comments and additional information about this user.
4. If Partitions are enabled (in the Site Information screen), choose the
partition(s) that this user is allowed to arm and disarm:
1, 2, 3, 1+2, 1+3, 2+3, 1+2+3
6.4 Panel Defintiions
Panel Definitions enables you to customize the control panel and adapt its
characteristics and behavior to the requirements of the particular user.
6.5 Communications Definitions
Communications Definitions enables you to set the telephone communication
parameters to the requirements of the particular Site.
6.6 PGM
PowerMax/PowerMaster control panels can open or close the programmable
(PGM) output as a result of a certain event or condition. This table enables you to
determine the events and conditions under which the PGM (programmable)
outputs will function.
Note: In some versions of the PowerMax+, the PGM will also include a scheduler,
(see 6.9 X-10 Device Settings for further details). When the X-10 device settings
table is uploaded, the Remote Programmer will also load the PGM table. However,
this does not occur the other way around.