User guide

Chapter 6: Data Details Tables
DE5450S Remote Programmer Guide Rev. 9 45
To Delete a Pendant
1. In the Pendant Enrollment table, click the Action button of the
pendant to be deleted.
2. From the dialog box, select the Delete Device radio button.
3. Click the Send to Panel button.
4. A new dialog box opens asking Are you sure?; click Yes.
5. Click Close.
The pendant is now deleted from the system.
6.19 Zone Definitions
Zone Definitions allows you to attribute one of the zone types to any one of the
wireless zones offered by the PowerMax/PowerMaster.
In the PowerCode version, you can assign a name to each zone and determine
whether the zone will operate as a chime zone while the system is in the disarmed
state.
After uploading data from the PowerMaster
∗
∗∗
∗
you can view the RF ID numbers of all
enrolled devices. The received signal strength indication (RSSI) of the device can
also be viewed after pressing on the UL Table icon and then pressing "OK".
In the PowerG version, zone monitoring and configuration can be set up in
separate tables dedicated to monitoring Motion, Contact, Smoke, Camera, Flood,
Gas, Hard Wired Devices, and Temperature.
6.20 Zone Status/Trouble
This table is applicable to the PowerG models.
The Zone Status/Trouble screen displays diagnostic information for all zones that
are set up, equipped, and monitored on the premises. A Yes indication alerts that a
condition exists that needs checking. A No indication means that the condition is
normal.
∗
∗∗
∗
Available in PowerMaster models only