User guide

Chapter 1: Introduction
DE5450S Remote Programmer Guide Rev. 9 1
Chapter 1: Introduction
The Visonic Remote Programmer is a utility program that enables you to manage
the PowerMax/PowerMaster alarm system from a remote station. It runs on IBM-
PC or compatible workstations and runs on Microsoft
®
Windows
®
7 (32 or 64-bit),
Microsoft
®
Windows
®
8 Desktop (32 or 64-bit) and Windows XP.
The Remote Programmer works with the new PowerG wireless technology and
PowerMaster alarm systems for intrusion alarm systems. When connected to
Visonic’s PowerG-based systems, the program provides superior diagnostic and
configuration capabilities, including performing walk-test from a remote location,
diagnostics of wireless network condition and complete configuration of all peripheral
devices in addition to configuring the alarm system control panel.
The Remote Programmer continues to support PowerCode-based systems and
PowerMax alarm systems.
Remote Programmer allows offline preparation of specifications, each of which is a
set of parameters especially tailored for a particular installation site. After preparing
the configuration, the remote programmer can download it into the alarm system
control panel locally using a cable or remotely via telephone.
Remote Programmer communicates with PowerMax and PowerMaster alarm
systems in two ways, as follows:
• locally through an USB/UART adapter that converts the signals to UART
TTL levels, as shown in figure 1-1,
• or, remotely via telephone lines and a modem, as shown in figures 1-2 and
1-3.
Local Data Transfer enables the operator to prepare the parameters for the alarm
system on a PC where he specifies parameters in the Site Screens, even though he
is working at the same installation site. He then transfers the data to the alarm
system through a cable.
LOCA
L SETUP
no modem is
required for
local download
COMPUTER
UART
TTL
POWERMASTER-10
UART
OVER
USB
USB
UART
ADAPTER
Figure 1-1: Setup for Local Data Transfer