User Manual

ManualsBrandsVisonic ManualsElectronicsMirror PIR detector

D-303372 TOWER-30AM PG2, TOWER-30AM K9 PG2 Installation Instructions 1

TOWER-30AM PG2 /

TOWER-30AM K9 PG2

WirelessPowerGHigh‐securityMirrorDetectorwith

Anti‐masking

Installation Instructions

1. INTRODUCTION

The TOWER-30AM PG2 and TOWER-30AM K9 PG2 (pet-immune) are 2-way, microprocessor-

controlled, wireless digital mirror PIR detectors which include the following features:



Adaptive Active Infra-Red Anti-Masking technology providing the most advanced reliable protection against

intentional masking attempts (patent pending)

 Includes a fully supervised PowerG transceiver.

 Incorporates patent pending black mirrors for extremely high white light immunity.

 Advanced elliptical / parabolic mirror technology (patent pending)

 Provides multiple curtain coverage (patent pending)

 V-slot® optic technology (patent pending) for improved robustness, anti-vandalism and for very high

reliability.

 Creep zone protection

 TOWER-30AM K9 PG2

can distinguish between human beings and pets weighing up to 18 kg (40 lb)

 The advanced True Motion Recognition™ algorithm (patented) allows distinguishing between the true

motion of an intruder and any other disturbances which may cause false alarms.

 Built-in link quality indicators; no need for the installer to physically approach the control panel thus

making installation faster and easier.

 No vertical adjustment is needed.

 Motion event counter determines whether 1 or 2 consecutive motion events will trigger an alarm.

 Automatic termination of walk-test after 15 minutes.

 Microprocessor-controlled temperature compensation.

 Sealed chamber protects the optical system.

 Front and back tamper protection.

 Self-test

A. Screw cover

B. LED

C. PIR optical window

Figure 1. General View

2. INSTALLATION

2.1 General Guidance (see Fig. 2)

1. Keep away from heat sources.

2. Do not expose to air drafts.

3. Do not install outdoors.

4. Avoid direct sunshine.

5. Keep wiring away from power cables.

6. Do not install behind partitions.

7. Mount on solid stable surface.

1 2 3

4 5 6

Figure 2. General Guidelines

Important! The detector is immune to 38 kg (85

lb) animals moving on the floor or climbing on

furniture as long as the activity takes place below

1 m (3 ft). Above the 1 m (3 ft) height limit, the

detector is immune to 19 kg (42 lb) pets, but the

pet immunity will decrease as the pet gets closer

to the detector. It is therefore recommended to

select a mounting location that minimizes

potential close proximity of animals.

WARNING! To comply with FCC and IC RF exposure compliance requirements, the PIR detector should be located at a distance of at least 20

cm from all persons during normal operation. The antennas used for this product must not be co-located or operated in conjunction with any other

antenna or transmitter

Summary of content (6 pages)

PAGE 1
TOWER-30AM PG2 / TOWER-30AM K9 PG2 Installation Instructions Wireless PowerG High‐security Mirror Detector with Anti‐masking 1.
PAGE 2
.2 Mounting 1 2 3 Note: For the desired detector's range and height, use mounting holes a or b , as specified in the table. 4 A C a b C a b ft m 10 3.0 9 2.7 8 2.4 7 2.1 6 1.
PAGE 3
1. On the indicated location, lift the screw cover upward using your thumb. 2. Release the screw and open the cover in the direction shown by the arrow. 3. Insert a screwdriver into the slot and then push inward to separate the base from the cover. 4. Set the desired detector range. 5. Insert battery while observing polarity. A. Mounting height B. Coverage range C. Break-away base segment (shaded) D. Enroll button (use a screwdriver to press the recessed button) E. Battery F.
PAGE 4
3. LOCAL DIAGNOSTICS TEST A. Separate the base from the cover (see Fig. 3). B. Put back the cover to return the tamper switch to its normal (undisturbed) position, and then secure the front cover to the base with the case closure screw. C. The TOWER-30AM PG2 will enter a 2 min. stability period. During this time the red LED blinks. D. Walk-test the coverage area - see Figure 4.
PAGE 5
– Consult the dealer or an experienced radio/TV technician. WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with FCC Rules Part 15 and with Industry Canada licence-exempt RSS standard(s).
PAGE 6
Storage Temperatures Humidity -20°C to 60°C (-4°F to 140°F) Average relative humidity of up to approximately 75% non-condensing. For 30 days per year the relative humidity may vary between 85 % and 95 % non-condensing PHYSICAL Size (H x W x D) Weight (with battery) Color 115 x 60 x 48 mm (4-1/2 x 2-5/16 x 1-15/16”) 90 g (3 oz). White PATENTS U.S.