User's Manual

D-303780 TOWER-32AM PG2, TOWER-32AM K9 PG2 Installation Instructions 1
TOWER
TOWERTOWER
TOWER-
--
-32AM
32AM32AM
32AM
PG2 /
PG2 /PG2 /
PG2 /
TOWER
TOWERTOWER
TOWER-
--
-32AM
32AM32AM
32AM
K9 PG2
K9 PG2K9 PG2
K9 PG2
Wireless PowerG, Dual Technology, Mirror,
PIR Motion Detector with Anti-mask
Installation Instructions
1. INTRODUCTION
1. INTRODUCTION1. INTRODUCTION
1. INTRODUCTION
The TOWER-32AM PG2 and TOWER-32AM K9 PG2 (pet-immune) Dual Technology are 2-way,
microprocessor-controlled, wireless digital mirror PIR detectors which include the following features:
Adaptive Active Infra-Red Anti-Masking technology providing the most advanced reliable protection
against intentional masking attempts (patent pending)
Includes a fully supervised PowerG transceiver.
24 GHz K-band microwave module.
Incorporates patent pending black mirrors for extremely high white light immunity.
Advanced elliptical / parabolic mirror technology (patent pending)
Provides multiple curtain coverage (patent pending)
V-slot® optic technology (patent pending) for improved robustness, anti-vandalism and for very high reliability.
Creep zone protection
TOWER-32AM K9 PG2 can distinguish between human beings and pets weighing up to 18 kg (40 lb)
The advanced True Motion Recognitionalgorithm (patented) allows distinguishing between the true
motion of an intruder and any other disturbances which may cause false alarms.
Built-in auto diagnostic for both PIR and microwave detectors.
Built-in link quality indicators; no need for the installer to physically approach the control panel thus
making installation faster and easier.
No vertical adjustment is needed.
Motion event counter determines whether 1 or 2 consecutive motion events will trigger an alarm.
Automatic termination of walk-test after 15 minutes.
Microprocessor controlled, digital TMR signal processing with dual-slope digital temperature compensation.
Sealed chamber protects the optical system.
Front and back tamper protection.
Microwave anti-masking
Disguise mo
de
that detects
an intruder who cloaks his IR radiation
C
B
A
A. Screw cover
B. LED
C. PIR optical window
Figure 1. General View
2
22
2.
. .
. INSTALLATION
INSTALLATIONINSTALLATION
INSTALLATION
2.1 General Guidance
(see Fig. 2)
1. Keep away from heat sources.
2. Do not expose to air drafts.
3. Do not install outdoors.
4. Avoid direct sunshine.
5. Keep wiring away from power cables.
6. Do not install behind partitions.
7. Mount on solid stable surface.
1 2 3
4 5 6
7
Figure 2. General Guidelines
Important! The detector is immune to 38 kg (85
lb) animals moving on the floor or climbing on
furniture as long as the activity takes place below
1 m (3 ft). Above the 1 m (3 ft) height limit, the
detector is immune to 19 kg (42 lb) pets, but the
pet immunity will decrease as the pet gets closer
to the detector. It is therefore recommended to
select a mounting location that minimizes potential
close proximity of animals.
WARNING! To comply with FCC and IC RF exposure compliance requirements, the PIR detector should be located at a distance of at
least 20 cm from all persons during normal operation. The antennas used for this product must not be co-located or operated in
conjunction with any other antenna or transmitter.

Summary of content (6 pages)