!R LSIMPLE™ RAILING SYS TE S COMPO NEN ‘ACCESSORIES CLEAR VIEW RAILING INSTALLATION GUIDE forestall Il o s etc using e Bt bl las admissibility i This document is a detailed step—by—step installation guide for the Clear view rail system. These instructions may not cover all scenarios that may arise. Before beginning your instillation take time to read all instructions thoroughly. A fundamental understanding of carpentry and a basic knowledge of power tools is essential.
@ Step 1 Install Newel Posts A) Set posts to accommodate required rail lengths. See detail 1-5, 1—8 for post attachment methods. Considering your tall height, posts may be trimmed to a desirable post height. [ Diagram 1-A @ Step 2 Trimming The Presorted Calls A) Measure the distance between posts. B) Mark the required length on both rails keeping the preregistered slots centered between the marks. C) Subtract at each end for tall hanger brackets. D) Trim the rails with a miter saw.
® A) Measure the distance between the posts. B} Mark the required length on the cap rail and trim with o miter saw. C) Apply exterior type Il glue to the top rail. Cap rail is fitted on top and nailed, 2 %" (63mm) galvanized nails @ 12" (600mm). See detail 1-3 Fasten the cap rail to the post using 2—4#8 x 2" {50mm) screws installed ot o 45 degree angle. See detail 1-1 and 1-3.
Page 3 Detail 1-5 Exterior Connection: Posts For Guards That Run Perpendicular to Deck Joists Minimum {12.7mm} Rim Holst diameter thru—bolts ond washers at the hold down anchor’s — attachment to Holst Trigonometric Hold down anchor Align guard post, at Holst locations % (12.7mm) Thru—Bolts And Washers Per Connection . L] = Rim joist Detail 1-5 Exterior Connection: Post Bolted to Rim Joist 1/2" (12.7mm) Thru—Bolts 1) Decking s omitted from plan view and the econometric view for clarity.
Page 4 !!!OVERSIMPLE RAILING SYSTEMS-COMPONENTS-ACCESSORIES For Technical support please call Instructions are also available on our website www.railsimple.com Tool List Hammer Ratchet Wrench Tape Measure Wood Chisel Miter saw Level Clamps Hand Drill Stainless Screws #8 x 2" (50mm) Drill Bit Size &" (3.