User`s manual

8
1 Sensor-in / Alarm-out
The sensor terminal block is used to connect a sensor such as PIR to the MiniD400. This will trigger the
device to event record.
The alarm output terminal is used to install a single alarm device.
2 SD Memory Slot
Insert SD Card into the slot for storing data.
3 Recording LED
This light illuminates when the MiniD400 is recording.
4 Status LED
This light blinks when events have occurred or there is an error.
5 Power LED
This light illuminates when the MiniD400 is powered up.
6 Remote control Receiver
When controlling MiniD400 by remote control, be sure to point at the receiver.
7 Reset
Press the reset button if you want to return setting values to the default.
8 AV-IN
Connect AV-IN connector
9 AV-OUT
Connect AV-OUT connector
10 Power
Connect 12V power supply in the package.