User manual

38
Vista QPlus H.264 V2.2 (RP03)
Quantum Plus H.264 installation and user manual
2-4. Motion
Motion on any channel can trigger recording of that camera. Resolution, Images Per second,
Audio, and Quality can all be configured individually per channel. As per Normal and Alarm
Recording Modes.
To setup the motion detection grid per channel select the “SEL” button.
The detection area is divided into a grid of 11x8 cells.
Default is all cells in active mode.
Use the Left right up down to move cursor and the
Select key to toggle between active (PINK) and
inactive (CLEAR).
The mouse can also be used to select cells and
toggle them on and off.
Care must be taken in setting of the motion
sensitivity. It is recommended that each level is
tested to find out which one suits that particular
camera site.
The motion detection is not recommended for external cameras.
Once a single camera has had its parameters set, these can be copied to selected cameras
by selecting the “Copy Camera Setting” button, the following window will be displayed:
Select the source camera and the cameras required to have the same settings then select
OK