Owner`s manual

13
Installation
DECIDING WHERE TO LOCATE YOUR PELLET APPLIANCE:
1. Do not install the stove in a bedroom or room where people sleep in.
2. Locate the stove in a large and open room that is centrally located in the
house. This will optimize heat circulation.
3. Check clearances to combustibles and for the least amount of interference to
house framing, plumbing, wiring, etc.
4. You can vent the stove with approved pipe through an exterior wall behind
the unit or pass it through the ceiling and roof. The stove can connect to an
existing masonry or metal chimney (must be lined if the chimney is over 6”
(15 cm) diameter, or over 28 inches² (180 cm²) cross sectional area).
5. This unit must not be installed directly onto carpet. If it is to be installed on
a carpeted area, a solid surface (wood, metal or approved hearth pad) must
be installed between the unit and the carpet.
6. This unit uses large quantities of air for combustion; outside Fresh Air
connection is strongly recommended. Fresh Air must be connected
where required by local codes.
7. Do not obtain combustion air from an attic, garage or any unventilated
space. Combustion air may be obtained from a ventilated crawlspace.
8. The power cord is 8 feet (2.43 m) long and may require a grounded extension cord to reach the
nearest electrical outlet.
AUTOMATIC SAFETY FEATURES OF YOUR PELLET STOVE:
A. EXHAUST TEMPERATURE SWITCH: The stove will shut off when the fire goes out and the exhaust
temperature drops below 49°C (120°F).
B. HIGH LIMIT SAFETY SWITCH: If the temperature on the hopper reaches 93°C (200°F), the auger will
automatically stop and the stove will shut down when the exhaust temperature cools. If this happens,
call your local dealer to reset the 93°C (200°F) high limit switch. ALSO FIND THE REASONS WHY
THE UNIT OVERHEATED.
C. VACUUM SWITCH: If the combustion fan fails or the exhaust vent becomes blocked this switch will
stop the auger feed motor and the fire will go out.
REMOVING PELLET STOVE FROM PALLET:
FREESTANDING: To remove your new freestanding stove from its pallet, remove the ash pan and remove
the two (2) wood screws inside this area as shown (see Figure 10). Also remove the two (2) wood screws
on the back of the pedestal. Remove the unit form the pallet and replace the ash pan.
INSERT: To remove your new insert stove from its pallet, remove the two (2) wood screws just inside
the unit (see Figure 11). Remove the unit form the pallet and install the pedestal (refer to “INSTALLATION
OF PEDESTAL - INSERT”)