VMVL2.1a Hands-Free Operating Instructions for Visteon MACH Voice Link Bluetooth Subsystem version 2.
VMVL2.1a Operating Instructions Table of Contents 1. 1.1. 1.2. 1.2.1. 2. 2.1. 2.2. 2.3. 2.4. 2.5. 2.6. 2.7. 2.8. 2.9. SUT Setup ...................................................................................................3 General SUT Description................................................................................3 Test Setup...................................................................................................3 Setup : Connection ..............................................
VMVL2.1a Operating Instructions 1. SUT Setup 1.1. General SUT Description Product Name: Visteon MACH Voice Link Bluetooth Subsystem version 2.1a Product ID: VMVL2.1a 1.2. Test Setup 1.2.1. Setup : Connection Test Setup consists of the VMVL2.1a (HF), Bluetooth antenna, load board, microphone and two powered speakers. Load board includes battery switch, ignition switch, Push-To-Talk (PTT) button and End button. VMVL2.1a connects to the load board’s 32way pin connector.
VMVL2.1a Operating Instructions 4 3 5 1 2 9 8 6 7 11 10 Figure 2: Setup Photo 1) VMVL2.
VMVL2.1a Operating Instructions 2. 2.1. VMVL2.1a (HF) Functions Pairing Once system is initialized as described in Section 1.2.1 user may pair an AG device to the HF by following the steps below. 1. 2. 3. 4. Press PTT button and wait for audible beep Release PTT button after audible beep Every voice recognition session begins at the HF’s Main Menu If no AGs are paired, HF will say “No phone paired. Would you like to pair one now?” 5. Say “Yes”. Go to step 7 6.
VMVL2.1a Operating Instructions 2.2. Initiate Outgoing Call from HF In order to initiate an outgoing call. An AG needs to be paired to the HF and have an active Bluetooth link. Follow the steps below in order to place a call in handsfree mode 1. 2. 3. 4. 5.
VMVL2.1a Operating Instructions 2.3. Initiate Outgoing Call from AG In order to initiate an outgoing call. An AG needs to be paired to the HF and have an active Bluetooth link. Follow the steps below in order to place a call in handsfree mode from the AG 1. Dial desired phone number from the AG 2. AG initiates call and SCO link is established 2.4. Terminate Call 1. Call is HF mode. 2. Press End button on the load board in order to terminate ongoing HF call or 3.
VMVL2.1a Operating Instructions 2.9. Call Waiting 1. HF has a call present 2. During an incoming call a beep will be heard signalling the second call 3. If user wants to accept the incoming call, user presses the PTT button on the HF, places the current call on hold and accepts the incoming call 4. User may switch between current call and call on hold by pressing the PTT button on the HF 5.
