User's Manual

VMVL2.1a Operating Instructions
Visteon Confidential Page 5 of 8
2. VMVL2.1a (HF) Functions
2.1. Pairing
Once system is initialized as described in Section 1.2.1 user may pair an AG device to the
HF by following the steps below.
1. Press PTT button and wait for audible beep
2. Release PTT button after audible beep
3. Every voice recognition session begins at the HF’s Main Menu
4. If no AGs are paired, HF will say “No phone paired. Would you like to pair one
now?”
5. Say “Yes”. Go to step 7
6. If an AG is already paired to HF, please say “Setup, Pair Phone” after you
press PTT and hear audible beep.
7. HF says “Please initiate pairing from your handset. For further instructions
refer to your phone’s user manual.”
8. Initiate pairing from AG
9. HF says “Please say the name for the phone”
10. Say name that you wish to give the AG
11. HF says “Please assign a priority level to <Phonename> by saying [1], [2],
[3], [4] or [5]” Up to five AGs may be paired to the HF, but only one will
have an active Bluetooth connection.
12. Say one number between 1 and 5
13. HF says “<Phonename> saved with a priority of <priority>”
14. HF says “Would you like to set a custom ring tone for <phonename>”
15. Say “No”. This will speed up the pairing process
16. HF says “No. The default ring tone has been assigned”
17. HF exits voice recognition session with ending beep
18. At this point the AG has completed pairing procedures with the HF. A
Bluetooth link between the HF and AG is established within 3-5 seconds after
pairing procedures are completed
19. HF is now ready to make outgoing handsfree calls or receive handsfree calls
Note: Voice recognition session may be terminated at any time by pressing and releasing
either PTT or End button or by saying “Cancel”