Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Attach ground (green) wire to ground wire from wall outlet box (usually green

or copper in color), fasten together with a plastic wire connector. Tightly wrap

the wire connector with electrical tape so the end of the connector is sealed.

IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE

PROPERLY GROUNDED.

2. Connect neutral (white) ﬁxture wire coming from ﬁxture base to neutral

(usually white) outlet wire. Fasten both wires together with a plastic wire

connector and tightly wrap the wire connector with electrical tape.

3. Repeat the procedure with the hot (black) wires. Always make sure that no

wire strands are left outside the connectors.

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR

SAFETY WILL BE COMPROMISED.

4. Remove mounting plate (A) from ﬁxture base (C) by removing cap nuts (D).

5. Afﬁx mounting plate (A) to wall outlet box with mounting screws (B) provided.

6. Attach ﬁxture base (C) to afﬁxed mounting plate (A), letting rods pass

through the holes of ﬁxture base (C) and secure with cap nuts (D).

7. Insert light bulb into socket.

8. Clip lamp shade (not included) onto the light bulb.

DRY

Ginger Single Arm Sconce

Item # AH2010