Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Attach ground (green) wire to ground wire from wall outlet box (usually green

or copper in color), fasten together with a plastic wire connector. Tightly wrap

the wire connector with electrical tape so the end of the connector is sealed.

IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE

PROPERLY GROUNDED.

2. Connect neutral (white) ﬁxture wire coming from ﬁxture base to neutral (usually

white) outlet wire. Fasten both wires together with a plastic wire connector and

tightly wrap the wire connector with electrical tape.

3. Repeat the procedure with the hot (black) wires. Always make sure that

no wire strands are left outside the connectors. DO NOT REVERSE THE

HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE

COMPROMISED.

4. To detach mounting plate (A) from ﬁxture base (C) by removing cap nuts (D).

5. Attach the mounting plate (A) to ceiling outlet box, align the mounting slots

with mounting holes of outlet box, insert mounting screws (B) to secure

mounting plate (A).

6. Gently push the ﬁxture base (C) onto the ceiling outlet, letting rods on

mounting plate (A) pass through the holes on the ﬁxture base (C) and tighten

by screwing cap nuts (D) to the exposed part of rods.

7. Insert light bulbs into sockets.

8. Remove ﬁnial (G) and washer (F) from center rod of(C).

9. Attach diffuser (E) to center rod of(C) and secure with washer (F) and cap nut

(G).

DRY

Randolph Small Flush Mount

Item # AH4200