Installation & Assembly

ASSEMBLY INSTRUCTIONS

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Remove mounting plate (A}from ﬁxture base (D) by unscrewing cap nuts (E).

2. Connect the safety steel wire from the ﬁxture to the safety cable from ceiling

with lock nut.

3. Connect the hot wire from the :ﬁxture (BLACK) to the hot wire from ceiling

outlet box (usually BLACK). Fasten them together with a plastic wire connector

provided and wrap connection with electrical tape.

4. Repeat this procedure for the WHITE neutral wires from the light ﬁxture to the

wire from ceiling outlet box (usually WHITE}.

5. Connect ground wire from the light ﬁxture (GREEN) to ground wire from

ceiling outlet box (usually green or copper in color).

6. Afﬁx mounting plate (A) onto ceiling outlet box and secure with mounting

screws (C).

7. Attach ﬁxture base (D) to afﬁxed mounting plate (A), letting rods (B) pass

through the holes on ﬁxture base (D), and secure with cap nuts (E).

8. Insert light bulbs into sockets.

9. Attach diffuser (F) to the bottom of :ﬁxture base (D), letting threaded rod at

bottom of (D) pass through center hole of the diffuser (F).

DAM P

Audrey Flush Mount

Item # AH4000

PAGE 1
ASSEMBLY INSTRUCTIONS Audrey Flush Mount Item # AH4000 WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. 1. Remove mounting plate (A}from fixture base (D) by unscrewing cap nuts (E). 2.