Installation & Assembly

ASSEMBLY INSTRUCTIONS
WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Connect the hot wire from the fixture BLACK) to the hot wire from ceiling
outlet box (A) (usually BLACK). Fasten them together with a plastic wire
connector (B) provided and wrap connection with electrical tape.
2. Repeat this procedure for the WHITE neutral wire from the light fixture to the
wire from ceiling outlet box (A) (usually WHITE).
3. Connect ground wire from the light fixture (GREEN or bare copper) to
ground wire from ceiling outlet box (A) (usually green or copper in color).
4. Remove mounting plate (C) from fixture base (G) by unscrewing ball nuts (I).
5. Affix mounting plate (C ) onto ceiling outlet box (A) and secure with mounting
screws (E).
6. Attach fixture base (G) to affixed mounting plate (C ), letting rods (D )on
mounting plate (C ) pass through the holes on fixture base (G ), and secure
with ball nuts (I).
7. Insert light bulbs (not included) into sockets (F). To avoid the risk of fire, do
not exceed the recommended wattage.
8. Attach diffuser (J) to fixture base (G), letting rod (H) pass through the center
rubber washer (M), hole of diffuser (J), rubber washer (N), and secure with
nut (K).
9. Restore power to outlet box and test fixture.
10. Installation is complete.
Basil Small Flush Mount
Item # AH4014
DAM P
(B)
(A)
(D)(L:30MM)
(E) (L:18MM)
(C)
(K)
(H)
(G)
(F)
(M)
(N)