Installation Sheet
ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Carefully remove all parts from the carton.
2. Remove mounting plate (A) from base of light fixture (D) by removing cap nut
(C) in counter-clockwise direction.
3. Affix mounting plate (A) to wall outlet box with mounting screws (B) provided.
4. Attach ground (green) wire to ground wire from wall outlet box (usually green
or copper in color ), fasten together with a plastic wire connector. Tighten
wrap the wire connect to with electrical tape. so the end of the connector is
sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
PROPERLY GROUNDED.
5. Connect neutral (white ) fixture wire coming from fixture base to neutral
(usually white) outlet wire. Fasten both wires together with a plastic wire
connector and tightly wrap the wire conncetor with electrical tape.
6. Repeat the procedure with the hot (black) wires. Always make sure that
no wire strands are left outside the connectors. DO NOT REVERSE THE
HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE
COMPROMISED.
7. Attach fixture base (D) to the affixedmounting plate (A) and tighten with cap
nut (C).
8. Insert light bulb (not included) Type B TORPEDO, maximum 40 watt into socket.
9. Insert glass shade (F) into shade holder (E).
*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
DAM P
Cylinder Sconce
Item # BBL2090
A
B
D
C
F
E