Installation Sheet
ASSEMBLY INSTRUCTIONS
Sweep Medium Left Articulating Sconce
Item # BBL 2162
.
DRY
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED
ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
TO ASSEMBLE:
*** (PORTABLE ASSEMBLY) *** (See Fig. 1)
1 Remove all parts carefully from the box.
2. Screw threaded nipple of cord cover (D) into bottom threaded opening of fixture base (C).
Thread cord cover (E) into cord cover (D) and hand tighten.
3. Measure the distance for the center points between both mounting holes at back of fixture
base (C). Mark two points with the same distance on the wall, make sure they are horizontal
with each other.
4. Drill small holes at both points, the holes should be big enough to accommodated with plastic
anchors (A). Install plastic anchors (A) into the holes in the wall.
5. Insert mounting screws (B) into plastic anchors (A), make sure screwhead with1/8" threads
are visible.
6. Hook fixture base (C) onto both screws (B).
7. Remove socket ring (J) from socket (H), place shade (I) over the socket (H) and secure with
socket ring (J).
8. Insert the specified light bulb (not included) into socket.
9. Place diffuser (K) on top of shade (I).
10. Remove plastic cover (G) from plug (F).
11. Plug lamp into wall outlet.
*** (HARD WIRE INSTALLATION) *** (See Fig. 2)
We strongly recommend that a professional electrician install the fixture.
Switch off the main electrical supply from the main fuse box/circuit breaker before installation.
1. Remove the key hole mounting plate from fixture base (C) by removing base screws (M).
2. Attach mounting plate (L) to wall outlet box with mounting screws (O) provided.
Guide wiring from wall outlet through center hole in mounting plate (L).
3. Cut fixture cord twelve inches away from fixture base (C) and remove by grasping plug (F)
and pulling out of cord cover (D & E).
4. Insert the DW plug (N) to the threaded hole vacated by the cord.
5. Connect the ground screw (green color) of the fixture to the bare copper ground wire in the
box. The insulation on the fixture cord that was cut to twelve inchers in step 3 has a smooth
side and a ribbed side. Connect the smooth wire to the black wire in the outlet box (not shown
in diagram). Connect the ribbed wire to the white wire in the outlet box.
6. Attach fixture base (C) to the affixed mounting plate (L), and secure with base screws (M).
7. Follow the steps of 7, 8, 9 of PORTABLE ASSEMBLY
8. Insert the specified light bulb (not included) into socket.
*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
A
G
H
H
B
D
E
C
F
M
N
L
O
C
K
K
J
J
I
I