Installation Sheet

ASSEMBLY INSTRUCTIONS

Halo Small Flush Mount

Item # BBL 4094

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED

ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Carefully remove all parts from the carton.

2. Remove mounting plate (A) from fixture base (F) by removing base screws (E).

3. Remove cap (C) from mounting plate (A) by removing cap nuts (D).

4. Affix mounting plate (A) to ceiling outlet box with mounting screws (B) provided.

5. Attach ground (green or green/yellow) wire to ground wire from ceiling outlet box

(usually green or copper in color ), fasten together with a plastic wire connector.

Tightly wrap the wire connector with electrical tape. so the end of the connector is

sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY

GROUNDED.

6. Connect both neutral (white ) fixture wire coming from fixture base to neutral (usually

white) outlet wire. Fasten both wires together with a plastic wire connector and tightly

wrap the wire connector with electrical tape.

7. Repeat the same procedure with the hot (black) wires. Always make sure that no wire

strands are left outside the connectors. DO NOT REVERSE THE HOT AND NEUTRAL

CONNECTIONS OTHERWISE SAFETY WILL BE COMPROMISED.

8. Replace cap (C) to mounting plate (A) and secure with cap nuts (D).

9. Attach fixture base (F) to mounting plate (A) and secure with base screws (E).

10. Restore power and test fixture. Installation is complete.

*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.

DAMP