Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Attach chain (F) to top loop (G).

2. Attach chain (F) to bottom loop of connection rod (E).

3. Afﬁx mounting strap (A) onto ceiling outlet box and secure with mounting

screws (B).

4. Thread top nipple of connection rod (E) into the center hole of canopy (C) and

secure with nut (D).

5. Attach ground (bare wire) wire to ground wire from junction box (usually green

or copper in color), fasten together with a plastic wire connector. Tightly wrap

the wire connector with electrical tape so the end of the connector is sealed.

IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE

PROPERLY GROUNED.

6. Connect neutral wire from ﬁxture (ridges molded wire) to neutral (usually

white) wire from junction box. Fasten both wires together with a plastic wire

connector and tightly wrap the wire connector with electrical tape.

7. Connect hot wire from ﬁxture (smooth wire) to hot wire (usually black) from the

junction box. Fasten each together with plastic wire connector. Make sure no

wire strands are exposed.

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS

OTHERWISE SAFETY WILL BE COMPROMISED.

8. Attach canopy (C) to the afﬁxed mounting strap (A), secure by threading the

nipple of connection rod (E) to center hole of mounting strap (A).

9. Slide shade (H) onto socket tubes.

10. Insert light bulbs (not included) into sockets.

11. Restore power and test ﬁxture.

Small Enameled Chandelier

Item # BBL5080