Installation Sheet

1. Carefully remove all parts from the box.

2. Hang up the hooks on one end of arm rods (I) into the metal circle on fixture (J).

3. Hang up the hooks on another end of arm rods (I) into the metal circle on centre box (H).

5. Unwrap the wiring from the centre box (H), twist power supply and ground wire together

7. Connect the fixture ground (bare) wire with the ground wire from the outlet box using wire

nuts (A).

If your house does not have ground wire, then attach this wire to the green Grounding screw

Inside of the outlet box.

IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.

8. Connect the fixture Neutral wire (ribbed, no markings) with the neutral wire from the

Outlet box using wire nuts (A).

9. Connect the fixture Hot (smooth edge,markings) wire with the hot wire from the outlet

Box using wire nuts (A).

11. Insert bulbs (not included) into the sockets.

12. Installation is complete, turn on power at fuse or circuit breaker.

***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.

Launceton Small Ring Chandelier

Item # CHC 1600

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE

BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY

DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

NOTE:CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO

REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND

INSTALLATION ARE FINAL.

Unscrew the quick link (F) on one end of chain (G) and hang it onto the center box (H),

close the quick link to secure the lamp body.

Crossbar (B).

6. Install the crossbar (B) with ceiling loop to the outlet box by mounting screws (C).

And pass through center hole of lock collar (E) , canopy (D) and ceiling loop with

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL

BE COMPROMISED.

10. Unscrew the quick link (F) on another end of chain (G) and hang it to the celling loop of

crossbar (B), close the quick link (F) and secure with Lock collar (E).