Installation Sheet
1. Carefully remove all parts from the box.
2. Hang up the hooks on one end of arm rods (I) into the metal circle on fixture (J).
3. Hang up the hooks on another end of arm rods (I) into the metal circle on centre box (H).
.
4. Hang up the quick link (F) on one end of chain (G) into the metal circle on top of
.
5. Unwrap the wiring from the centre box (H), twist power supply and ground wire together
.
.
7. Connect the fixture ground (bare) wire with the ground wire from the outlet box
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
8. Connect the fixture Neutral wire (ribbed, no markings) with the neutral wire from the
Outlet box using wire nuts (A).
9. Connect the fixture Hot (smooth edge,markings) wire with the hot wire from the outlet
Box using wire nuts (A).
11. Place candle tubes (K) into the sockets and Insert bulbs (not included) into the sockets.
12. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Launceton Ring Chandelier
Item # CHC 1601
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE:CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTILL INSPECTION AND
INSTALLATION ARE FINAL.
DRY
Centre box (H).
Crossbar (B).
6. Install the crossbar (B) with ceiling loop to the outlet box by mounting screws (C).
And pass through center hole of lock collar (E) , canopy (D) and ceiling loop with
screw Inside of the outlet box.
using wire nuts (A).
If your house does not have ground wire, then attach this wire to the green Grounding
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL
BE COMPROMISED.
10. Hang up the quick link (F) on another end of chain (G) to the celling loop (C) and
secure with Lock collar (E).