Installation Sheet

1. Carefully remove all parts from the box.
2. Hang the center cluster (I) to the hook (H), let the cord and groundwire pass through
the hole in top loop (G).
3. Provide a 1/4” IPS pipe with one end securely mounted to a beam or a structural member.
The other end should protrude through the center of the outlet box as shown.
4. Install the threaded nipple (B) into the support pipe and adjust overall length to allow the
canopy ring to hold the canopy flush to the ceiling.
5. Put canopy (D) flush to the ceiling, and secure with collar ring (E).
6. With the fixture desired height, shorten the chain (F) as needed using a pair of chain
pliers.
7. Open the chain quick link, then attach the chain quick link to the ceiling loop (C). Secure
the chain quick link.
8. Open the chain quick link, then attach the chain quick link to the fixture top loop (G).
Secure the chain quick link.
9. Weave the power supply cord and the ground wire through the chain (F).
10. When you reach the canopy and collar loop (C), measure the wires then cut. Be certain
to leave enough to connect inside of the outlet box.
11. Strip the insulation back on the two power supply wires about 5/8".
12. Loosen the collar ring (E) and let the canopy (D) slip down the chain carefully.
13. Twist the power supply and ground wire together and push through the center hole of
the collar loop (C).
Darlana XXL Lantern
Item # CHC 2172
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DRY