Installation Sheet
1. Carefully remove all parts from the box.
2. A 1/4" threaded nipple must be installed in your outlet box. Then install the threaded
nipple (B) into the outlet box.
3. Attach the glass panel (H) to the frame.
4. Insert bulbs (not included) into the sockets.
5. Unscrew the threaded collar on the chain end link (J) and attach it to the top ring (K).
Close the threaded collar to secure the fixture body.
6. Let canopy (D) and lock collar (E) go through the chain (F).
7. With the fixture dimension as a guide, shorten the chain (F) as needed using a pair
of chain pliers.
8. Unscrew the threaded collar on the other chain end link, raise the fixture then attach
chain end link to the ceiling loop (C). Close the threaded collar to secure.
9. Unwrap the wiring from the top of the fixture body. Weave the power supply cord and
the ground wire through the chain (F).
10. When you reach the canopy and ceiling loop, measure the wires then cut. Be certain
to leave enough to connect inside of the outlet box.
11. Strip the insulation back on the two power supply wires about 5/8".
12. Twist the power supply and ground wire together and push through the center hole of
the ceiling loop (C).
13. Connect the fixture ground (bare) wire with the ground wire from the outlet box using
wire nut (A). If your house does not have ground wire, then attach this wire to the
green grounding screw inside of the outlet box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
Plantation Small Lantern
Item # CHC 3438
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIALLY UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP
TO assemble safety cables:
1.Join fixture safety cables with safety
cable from ceiling.
2.Wrap both safety cable around the
cable lock nut.
3.Insert screws into both holes on cable
lock nut,secure screws with screwdriver.
4.Push the cable lock nut into outlet box.