Installation Sheet

Connect the hot wire (BLACK)from the fixture to the hot wire from ceiling outlet box

( usually BLACK). Fasten them together with a plastic wire connector provided.

Repeat this procedure for the neutral wire (WHITE) from the light fixture to the wire from

ceiling Outlet box(usually WHITE).

Connect ground wire from the light fixture ( bare copper) to ground wire from ceiling outlet

Box ( usually green or copper in color).

Carefully remove all parts from the box.

Remove the mounting plate (C) from the fixture(E) by removing the ball nuts (F).

Installation is complete, turn on power at fuse or circuit breaker.

***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.

Launceton Medium Flush Mount

Item # CHC 4603

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY

DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO

REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND

INSTALLATION ARE FINAL.

DAMP

IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.

10.

11.

Tuck these wire connections neatly into the ceiling outlet box.

Through the rubber washer(H-1) to nipple of thread(J), install the glass shade(G) to

the thread(J),then through the rubber washer(H-2) to the nipple of thread(J), and then

secure with the finial(I).

Put mounting plate(C) flush on the ceiling and marked the point for anchor(A),drill

4 holes on ceiling,then knock the anchors(A) to the ceiling holes.

Install the mounting plate(C) to the outlex box with the mounting screw(K) and wood

screws(D)provided.

Install the fixture(E) to the mounting plate(C) with ball nuts(F) provided.

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS, OR

SAFETY WILL BE COMPROMISED.