Installation Sheet
1. Carefully remove all parts from the box.
2. Install the crossbar (B) with ceiling loop (D) to the outlet box by mounting screws (C)
provided.
3. Unscrew the threaded collar (E) on the chain end and attach it to top ring of fixture (J)．
Close the threaded collar to secure the fixture (J).
4. Let canopy (F) and lock collar (G) go through the chain (H).
5. With the fixture dimension as a guide, shorten the chain (H) as needed using a pair
of chain pliers.
6. Unscrew the threaded collar (E) on the other chain end, raise the fixture (J) then attach
the threaded collar (E) to the ceiling loop (D). Close the threaded collar (E) to secure.
7. Unwrap the wiring from the top of fixture (J). Weave the power supply cord and
Pass the cord through the lock collar (G),canopy (F) and ceiling loop (D).
.
8. Connect the fixture ground (bare) wire with the ground wire from the outlet box using
wire nuts (A). If your house does not have ground wire, then attach this wire to the
green grounding screw inside of the outlet box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
9. Connect the fixture Neutral wire (ribbed, no markings) with the neutral wire from the
outlet box using wire nuts (A).
Cynara Large/Medium Chandelier
Item # CHC 5157／ CHC 5165
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
10. Connect the fixture Hot (smooth edge,markings) wire with the hot wire from the outlet
Box using wire nuts (A).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL
BE COMPROMISED.
11. Tuck these wire connections neatly into the outlet box to secure.
12. Put canopy (F) to the ceiling loop (D), and secure with lock collar (G).
13. Unscrew the socket neck from fixturue (J) by knurled screws (G).
14. Install the bulb (not included) into the socket.