Installation Sheet

1. Carefully remove all parts from the box.
2. Install the mounting plate (B) to the juntion box with mounting screws (C) provided.
3. Put canopy (E) flush to the ceiling, and secure with collar ring (F).
4. With the fixture desired height, shorten the chain (G) as needed using a pair of chain
pliers.
5. Open the chain quick link, then attach the chain quick link to the ceiling loop (D). Secure
the chain quick link.
6. Attach the rods (I) one end to the hook on the fixture top loop (H), one end to the hook
on the ring of fixture body (J).
7. Open the chain quick link, then attach the chain quick link to the fixture top loop (H).
Secure the chain quick link.
8. Weave the power supply cord and the ground wire through the chain (G).
9. When you reach the canopy and collar loop (D), measure the wires then cut. Be certain
to leave enough to connect inside of the outlet box.
10. Strip the insulation back on the two power supply wires about 5/8".
11. Loosen the collar ring (F) and let the canopy (E) slip down the chain carefully.
12. Twist the power supply and ground wire together and push through the center hole of
the collar loop (D).
13. Connect the fixture ground (bare) wire with the ground wire from the junction box using
wire nut (A). If your house does not have ground wire, then attach this wire to the
green grounding screw inside of the junction box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
Darlana Extra Large Single Ring Chandelier
Item # CHC 5173
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DRY