Installation Sheet

1. Carefully remove all parts from the box.
2.
Unwrap the wiring from the centre box (L), twist power supply and ground wire together
5. Connect the fixture ground (bare) wire with the ground wire from the outlet box using
wire nuts (A).
If your house does not have ground wire, then attach this wire to the green Grounding
screw Inside of the outlet box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
6.
Connect the fixture Neutral wire (ribbed, no markings) with the neutral wire from the
Outlet box using wire nuts (A).
7.
Connect the fixture Hot (smooth edge,markings) wire with the hot wire from the outlet
Box using wire nuts (A).
11. Insert bulbs (not included) into the sockets.
12. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Alborg Large Stacked Pendant
Item # CHC5245
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE
BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE:CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
3.
Unscrew the quick link (F) on one end of chain (G), and the quick link (H) to the other
end of the chain (G).
4.
Install the crossbar (B) with ceiling loop to the outlet box by mounting screws (C).
And pass through shade (K), (J) & (I), then pass through cennter hole of lock collar (E) ,
canopy (D) and ceiling loop with crossbar (B).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL
BE COMPROMISED.
8. Hang the quick link (F) to the celling loop of crossbar (B), close the quick link (F) and
secure with Lock collar (E).
Fix the shade bracket (M) to the lamp holder (L) by socket ring (N).
9.
Place the shade (K), (J0 & (I) to the brakcet (M), hang the quiick link (H) to the lmap
hodler (L).
10.