Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Carefully remove the mounting plate (B) from the back plate (E) by removing
side screws(C).
2. Secure the mounting plate (B) to the outlet box in your wall using the two
mounting screws (D).
3. Attach the ground wire from the fixture to the ground wire from the building
using the provided wire nuts (A). If you house has no ground wire attach this
wire to the green grounding screw inside the outlet box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
4. Attach the common wire (ribbed, no words) from the fixture to the white wire
from the building using the provided wire nuts (A).
5. Attach the hot wire (smooth, with words) from the fixture to the black wire from
the building with the provided wire nuts (A).
6. Secure each connection by tightening and then checking that no wires can be
pulled out. IT IS IMPERATIVE THAT YOU NOT MIX THESE WIRES.
7. Secure back plate (E) to mounting plate (B) with flat head screws (D).
8. Thread cord cover (F) into the hole on the bottom of back plate (E).
9. Attach harp (I) to harp saddle (L).
10. Attach shade (H) (not include) to harp (I) and secure with finial (G).
11. Install lamp bulb (J) (not included) into socket.
12. Restore power and enjoy your new fixture.
Large Ring Wall Sconce
Item # CHD2970