Installation Sheet
1. Carefully remove all parts from the box.
2. Remove the mounting plate (C) from the backplate (G) by loosening the side screws (F).
3. Put the mounting plate (C) on the wall and mark the holes position with pencil.
4. Drill 4 holes on the wall and knock the anchors (B) into the holes.
5. Affix mounting plate (C) onto the junction box and secure with mounting screws (E), then
secure the wood screws (D) to the anchors (B) and lock tight.
6. Connect the fixture Ground (bare) wire with the ground wire from the outlet box using
wire nut (A). If your house does not have ground wire, then attach this wire to the
green grounding screw inside of the outlet box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
7. Connect the fixture Neutral wire (WHITE) with the neutral wire from the outlet box
using wire nut (A).
8. Connect the fixture Hot (BLACK) wire with the hot wire from the outlet box using wire
nut (A).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL
BE COMPROMISED.
9. Attach backplate (G) to the mounting plate (C) and secure with side screws (F).
10. Open the front door of the fixture body, place glass panels (H) on the side of the frame
and secure it by bending the metal tabs.
11. Place glass panel (I) on the door of the frame and secure it by bending the metal tabs.
12. Insert bulb (not included) into the socket, then close the door.
13. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
WITH SILLICONE CAULKING COMPOUND, CAULK COMPLETELY AROUND WHERE
BACK OF CANOPY MEETS THE WALL SURFACE TO PREVENT WATER FROM SEEPING
INTO J-BOX.
Charlestown Small 3/4 Wall Lantern
Item # CHO 2028
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
WET
L
I
S
T
E
D
C
US
Intertek
CM