Installation Sheet

1. Carefully remove all parts from the box.

2. Remove the mounting plate (B) from the backplate (E) by loosening the side screws (D).

3. Attach the mounting plate (B) to the outlet box then secure with mounting screws (C).

4. Connect the fixture Ground (bare) wire with the ground wire from the outlet box using

wire nut (A). If your house does not have ground wire, then attach this wire to the

green grounding screw inside of the outlet box.

IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.

5. Connect the fixture Neutral wire (WHITE) with the neutral wire from the outlet box

using wire nut (A).

6. Connect the fixture Hot (BLACK) wire with the hot wire from the outlet box using wire nut (A).

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL

BE COMPROMISED.

7. Attach backplate (E) to the mounting plate (B) and secure with side screws (D).

8. Insert bulbs (not included) into the sockets.

IMPORTANT: PLEASE FOLLOWING BELOW ASSEMBLY PROCESS STRICTLY

OTHERWISE THE GLASS WILL BE VERY DIFFICULT TO INSTALL.

9. Place glass panels (L) &(M) on the frame (F) and screw it by bending the metal tabs.

10. Place glass panels (I)&(J)&(K) on the frame (F) and screw it by bending the metal tabls,

and makesure the glass panels outside with plastic rod.

11. Place glass panels (N) on the frame (F) and screw it by bending the metal tabs.

12. Installation is complete, turn on power at fuse or circuit breaker.

***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.

WITH SILLICONE CAULKING COMPOUND, CAULK COMPLETELY AROUND WHERE

BACKPLATE MEETS THE WALL SURFACE TO PREVENT WATER FROM SEEPING

INTO J-BOX.

Darlana Tall 3/4 Wall Lantern

Item # CHO 2087

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY

DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO

REMOVING. RETAIN ALL PACKING MATERIALLY UNTIL INSPECTION AND

INSTALLATION ARE FINAL.

WET

B A

OUTLET BOX

Bulb

(Not included)

Glass

Plastic