Installation Sheet

1. Carefully remove all parts from the box.
2. Remove the mounting plate (B) from the canopy (H) by unscrewing the collar ring (I).
3. Install the mounting plate (B) to junction box and secure with the mounting screws (C).
4. Remove the metal bars (M) from the fixture body (K) by unscrewing the screws (N) using the
screwdriver (O) provided.
5. Attach the glass panels (L) to the fixture body (K) and secure with the metal bars (M) and
secure with screws (N) using the screwdriver (O) provided.
DO NOT OVER-TIGHTEN SCREWS , OTHERWISE GLASS COULD BECOME DAMAGED.
6. Feed the wires through the rod (J) ,collar ring (I) ,canopy (H) and rod (G).
7. Thread the rod (J) to the fixture body (K), then thread the rod (G) to the rod (J).
8. Hang the fixture swivel ball (F) to the center of the mounting plate (B) and secure with the
set screw (D) using the wrench (E).
9. Measure the wires then cut, be certain to leave enough length to connect to the wires in the
junction box.
10. Strip the insulation on the fixture wires about 5/8".
11. Wrap the fixture ground wire to the green ground screw on the mounting plate (B) and
secure, then connect to ground wire in the junction box using wire nut (A).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
Fresno Small Hanging Lantern
Item # CHO 5932
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
ASSEMBLY INSTRUCTIONS
US
M
L
I
D
S
E
T
A
B
C
D
E
F
G
H
I
Junction Box
J
K
Bulb(Not included)
M
N
O
L(4pcs)
DE
DAMP