Installation Sheet

1. Carefully remove all parts from the box.

2. Remove the mounting plate (B) from the fixture body (E) by unscrewing the set screw (D)

using the wrench provided.

3. Install the mounting plate (B) to the junction box and secure with the mounting screws (C).

4. Wrap the fixture ground wire to the green ground screw on the mounting plate (B) and

secure, then connect to the ground wire in the junction box using the wire nut (A).

IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.

5. Connect the fixture white wire to the neutral wire in the junction box using the wire nut (A).

6. Connect the fixture black wire to the hot wire in the junction box using the wire nut (A).

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY

WILL BE COMPROMISED.

7. Install the fixture body (E) to the mounting plate (B) and secure with the set screw (D).

8. Insert bulb (not included) into the socket.

9. Installation is complete, turn on power at fuse or circuit breaker.

***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.

Alberto Medium Sconce

Item # JN 2002

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY

DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO

REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND

INSTALLATION ARE FINAL.

ASSEMBLY INSTRUCTIONS

Bulb(Not included)

Wrench

DCBJunction box A

DAMP