Installation Sheet
1. Carefully remove all parts from the box.Then remove the plastic sleeve on the wire
before assembling.
2. Thread the tube (L) to the top of the light component (N).
3. Attach the hook (J) to the tube (L) and secure with top ring (I).
4. Attach the metal sheet (Q) and glass panel (P) to the metal frame (M) and secure with
rubber washer and nut (O & R).
5. Hang the rod (K) one end to the hook (J), one end to the metal frame (M).
6. Install the mounting plate (B) with ceiling loop (D) to the outlet box by mounting screws
(C) provided.
7. Unscrew the threaded collar on the chain end link (H) and attach it to the top ring (I).
Close the threaded collar to secure the fixture body.
8. Let canopy (E) and lock collar (F) go through the chain (G).
9. With the fixture dimension as a guide, shorten the chain (G) as needed using a pair
of chain pliers.
10. Unscrew the threaded collar on the other chain end link, raise the fixture body, then
attach chain end link to the ceiling loop (D). Close the threaded collar to secure.
11. Unwrap the wiring from the top of the fixture body. Weave the power supply cord and
the ground wire through the chain (G).
12. When you reach the canopy and ceiling loop, measure the wires then cut. Be certain
to leave enough to connect inside of the outlet box.
13. Strip the insulation back on the two power supply wires about 5/8".
14. Twist the power supply and ground wire together and push through the center hole of
the ceiling loop (D).
Caddo Medium Lantern
Item # JN 5020
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP