Installation Sheet
1. Carefully remove all parts from the box.
2. Remove the collar loop (C) from the chain (F) by unscrewing the quick link (R).
3. Install the mounting plate (A) and collar loop (C) to the junction box with mounting
screws (B) provided. Using a wrench (not provided) secure the mounting plate (B) and
collar loop (C) to the threaded nipple using provided hex nuts.
4. Install the canopy (D) to collar loop (C) and secure with collar ring (E). If needed, adjust
collar loop (C) height by loosening hex nuts and screwing collar loop (C) up or down then
re-secure.
5. Gently set the fixture arms (L) to the hub (K) and secure with the washers (O) and
hex nut (P) using the wrench (N). Check that the arms are spaced evenly
before final tightening.
6. Connect the fixture arms (L) ribbed wire (no markings) to the fixture ribbed wire (no markings)
and connect ribbed wire (no markings) with CE-5 wire nuts (Z) and wrap the connection with
the electrical tape (not included) as shown in the diagram1.
7. Connect the fixture arms (L) smooth wire (with markings) to the fixture smooth wire
(with markings) and connect smooth wire (with markings) with CE-5 wire nuts (Z) and wrap
the connection with the electrical tape (not included) as shown in the diagram 1.
8. Weave the fixture wires through hub cap (J) and coupling (I) then rod (H).
9. Install the hub cap (J) to the hub (K) and secure with the coupling (I), then thread the rod (H)
to the coupling (I).
10. With the fixture desired height, shorten the chain (F) as needed using the chain
pliers (not included).
Clarice Large Chandelier
Item # JN 5030
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
ASSEMBLY INSTRUCTIONS
US
M
L
I
D
S
E
T
DRY
A
B
C
E
F
G
H
D
I
J
K
M
N
L
M
O
P
T
U
S
R
R
Q
L
O
P
K
N
Z
Y
diagram 1
diagram 2