Installation Sheet

1. Carefully remove all parts from the box.
2. nsert bulb (not included) into the socket.
3. Attach the glass shade (M) to the metal plate (K) and secure with screws (L).
4. Put the metal cap (H) on the top of the glass shade (M).
5. Install the mounting plate (B) with ceiling loop (D) to the outlet box by using mounting
screws (C).
6. Unscrew the threaded collar on the chain end link (I) and attach it to the top ring (J).
Secure the threaded collar to secure the fixture body.
7. Let canopy (E) and lock collar (F) go through the chain (G).
8. With the fixture dimension as a guide, shorten the chain (G) as needed using a pair
of chain pliers.
9. Unscrew the threaded collar on the other chain end link,raise the fixture then attach
chain end link to the ceiling loop (D). Secure the threaded collar to secure the chain.
10. Unwrap the wiring from the top of the fixture body. Weave the power supply cord and
the ground wire through the chain (G).
11. When you reach the canopy and ceiling loop, measure the wires then cut. Be certain
to leave enough to connect inside of the outlet box.
12. Strip the insulation back on the two power supply wires about 5/8".
13. Twist the power supply and ground wire together and push through the center hole of
the ceiling loop (D).
Lucia Medium Pendant
Item # JN 5051
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP
Insert bulb (not included) into the socket.