Manualshelf

Installation Sheet

ManualsBrandsVisual Comfort ManualsChandeliersFarfalle 40" Large Butterfly Chandelier by Julie Neill
12345
1. Carefully remove all parts from the box.
2. Feed the fixture wires pass through the rod (H), then thread the rod (H) to the top of
the fixture body (I).
3. Feed the fixture wires pass through the rod (G), collar ring (F) and canopy (E), then thread
the rod (G) to the rod (H).
4. Install the mounting plate (B) to the junction box by the mounting screws (C) provided.
5. Hang the fixture swivel ball (J) on the center of the mounting plate (B) and secure with
the set screw (D) by using the wrench provided.
6. Wrap the junction box ground wire to the green ground screw on the mounting plate (B) and
secure, then connect to the fixture ground wire in the junction box using the wire nut (A).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
7. Connect the fixture ribbed wire (no markings) to the neutral wire in the junction box using
the wire nut (A).
8. Connect the fixture smooth wire (with markings) to the hot wire in the junction box using
the wire nut (A).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL
BE COMPROMISED.
9. Carefully tuck the wire connections into the junction box.
10. Install the canopy (E) to the mounting plate (B) and secure with the collar ring (F).
11. Insert bulbs (not included) into the sockets.
12. Assemble the branches as below figures show tier by tier from L1 to L11 .
13. Thread the branch (P) to the finial (R) on the bottom of the center ball.
14. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Farfalle Large Chandelier
Item # JN 5502
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
ASSEMBLY INSTRUCTIONS
US
M
L
I
D
S
E
T
Junction box
wrench
A
B
C
D
E
J
F
G
H
Bulb(Not included)
I
DRY

Summary of content (5 pages)