Installation Sheet

1. Carefully remove all parts from the box.
2. Thread the rod (I) to the nipple (J) on the fixture body.
3. Install the crossbar (B) with ceiling loop (D) to the ceiling junction box by mounting screws
(C) provided.
4. With the fixture desired height, shorten the chain (G) as needed using a pair of chain
pliers.
5. Open the one chain quick link, then attach the chain quick link to the top ring (H). Secure
the chain quick link.
6. Let collar ring (F) and canopy (E) go through the chain (G).
7. Open the another chain quick link, then attach the chain quick link to the ceiling loop (D).
Secure the chain quick link.
8. Weave the fixture wire and the ground wire through the chain (G).
9. Feed the fixture wire and ground wire through the ceiling loop (D) and pull until taut.
Measure the wires then cut. Be certain to leave enough length to connect inside of the
ceiling junction box.
10. Strip the insulation back on the two power supply wires about 5/8".
11. Connect the fixture ground (bare) wire with the ground wire from the junction box using
wire nut (A). If your house does not have ground wire, then attach this wire to the
green grounding screw inside of the junction box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
Dumaine Medium Pierced Leaf Chandelier
Item # JN 5517
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP