Installation & Assembly
1. Carefully remove all parts from the box.
2. Provide a 1/4” IPS pipe with one end securely mounted to a beam or a strucral member.
The other end should protrude through the center of the outlet box as shown.
3. Install the threaded nipple (B) into the support pipe and adjust overall length to allow the
canopy ring to hold the canopy flush to the ceiling.
4. With the fixture desired height, shorten the chain (F) as needed using a pair of chain
pliers.
5. Open the chain quick link, then attach the chain quick link to the top ring (G). Secure
the chain quick link.
6. Let collar ring (E) and canopy (D) go through the chain (F).
7. Open the chain quick link, then hang the fixture body onto the ceiling loop (C). Secure
the chain quick link.
8. Weave the power supply cord and the ground wire through the chain (F).
9. When you reach the canopy and ceiling loop, measure the wires then cut. Be certain
to leave enough length to connect inside of the outlet box.
10. Strip the insulation back on the two power supply wires about 5/8".
11. Twist the power supply and ground wire together and push through the center hole of
the ceiling loop (C).
12. Connect the fixture Ground (bare) wire with the ground wire from the outlet box using
wire nut (A). If your house does not have ground wire, then attach this wire to the
green grounding screw inside of the outlet box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
Strada Large Linear Chandelier
Item # KW 5182
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP
(Not provided)
1/4 IPS threaded nipple pipe
TO assemble safety cables:
1.Join fixture safety cables with safety
cable from ceiling.
2.Wrap both safety cable around the
cable lock nut.
3.Insert screws into both holes on cable
lock nut,secure screws with screwdriver.
4.Push the cable lock nut into outlet box.
Safety cable
Cable lock nut
Ceiling Box