Installation Sheet
1.
2.
3.
Measure centre points between both mounting holes at back of fixture base. Mark
two points with same distance on the wall, make sure they are vertical with each other.
4.
7.
9.
12.
Installation is complete, turn on power at fuse or circuit breaker.
Walker Swing Arm Sconce
Item # KS2075
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED
ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/
CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION
ARE FINAL.
8.
Install the holder(E) to the socket cup by twist the ring (F)
10.
11.
Insert bulb (not included) into the socket.
Install the shade(G) ,finial(H) and diffuser(I) to the fixture .
Remove protective plug cover(J) from the plug.
Plug into a proper electrical outlet and test the fixture.
DRY
Carefully remove all parts from the box.
Insert mounting screws (B) into plastic anchors (A), make sure screwhead 1/8’’ threads are
visible.
5.
6.
Hook fixture base onto both screws (B).
*** (CORD COVER ASSEMBLY) *** (See Fig.1)
*** (DIRECT WIRE INSTALLATION) *** (See Fig.2)
We strongly recommended that a profssional electician install the fixture.
DIRECT WIRE
MOUNTING PLAT
(Fig.2)
CORD COVER
MOUNTING OPTION
(Fig.1)
1..
Follow step 1 of the CORD COVER ASSEMBLY
2.
. Guide wiring from wall outlet through centre hole in mounting plate (B)
3.
.
4.
5. Attach fixture base to the affixed mounting plate (B), and secure with base screws (E).
.
Thread the thread pitch (F) into bottom threaded opening of fixture base .
***Clean with a dry, soft cloth only.Use no harsh abrasives or chemical agents.
Affix mounting plate (B) to wall outlet box with mounting screws (C). Cut fixture cord twelve
inch away from fixture base and remove by grasping plug and pulling out of cord cover (D).
Connect the ground screw (green color) of the fixture to the bare cooper ground wire
in the outlet box. The insulation on the fixture cord that was cut to twelve inches in length in
step 3 has a smooth side and ribbed side. Connect the smooth wire to the black wire in the
outlet box (not shown in diagram) by wire nuts (A). Connect the ribbed wire to the white wire
in the outlet box by wiring nuts (A).
7.
Follow steps 7,8,9 of CORD COVER ASSEMBLY
Drill small holes at both points,holes should be big enough to accommodate with plastic
.
Screw thread nipple of cord cover (D) into bottom threaded opening of backplate.
6.
anchors (A). Install plastic anchors (A) into the holes in the wall.