Installation Sheet

DRY

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR

OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

RL 2329

ASSEMBLY & INSTALLATION GUIDE

1. Carefully remove all parts from the carton.

2. Remove mounting plate (A) from base of light fixture (D) by removing base screws (C)

in counter-clockwise direction.

3. Affix mounting plate (A) to wall outlet box with mounting screws (B) provided.

4. Attach ground (green) wire to ground wire from wall outlet box (usually green or copper

in color ), fasten together with a plastic wire connector. Tighten wrap the wire connector

with electrical tape. so the end of the connector is sealed. IT IS IMPERATIVE THAT THE

OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.

5. Connect neutral (white ) fixture wire coming from fixture base to neutral (usually white )

outlet wire. Fasten both wires together with a plastic wire connector and tightly wrap the

wire connector with electrical tape.

6. Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are

left outside the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS

OTHERWISE SAFETY WILL BE COMPROMISED.

7. Attach fixture base (D) to the affixed mounting plate (A) and secure with base screws (C).

8. Remove set screws (F) from fixture base (D), attach shade (E) to top of fixture base (D) and

secure with set screws (F).

9. Insert light bulb into socket.

10. Installation is complete. Restore power and test fixture.

*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.