Installation Sheet
.
DRY
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED
ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Carefully remove all parts from the carton.
2. Hook the assembly part (L) to the hook rack (J).
3. Attach chain (G) to top loop (H) on light fixture.
4. Feed wire through chain (G) and chain mounting loop (D).
5. Slide canopy (D) and canopy ring (F) on chain (G).
6. Attach mounting strap (A) to ceiling outlet box and secure with mounting screws (B).
7. Insert top thread nipple (C) in mounting strap (A).
8. Attach chain mounting loop (E) to thread nipple (C).
9. Attach chain (G) with fixture to chain mounting loop (E) at desired height.
10. Attach the ground wire (bare wire) from the fixture to the ground junction box wire
(usually green or copper wire). Fasten together with a plastic wire connector and
wrap the connection with electrical tape. Be sure no wire strands are exposed.
11. Connect the neutral wire from the fixture (ridges molded wire) to the neutral wire from
the junctionbox (usually white). Fasten together with a plastic wire connector and
wrap the connection with electrical tape.Be sure nowire strands are exposed.
12. Connect the hot wire from the fixture (smooth wire) to the hot
wire (usually black) from the junction box. Fasten each together
with a plastic wire connector and wrap the connection with electrical
type. Be sure that no wire strands are exposed. DO NOT REVERSE
THE HOT AND NEUTRAL CONNECTIONS OTHERWISE
SAFETY WILL BE COMPROMISED.
13. Tuck the wire connections neatly into the ceiling outlet box.
14. Slip canopy (D) to ceiling and secure with threaded canopy ring (F).
15. Insert light bulbs into the sockets.
16. Clip shades (K) onto the light bulbs.
17. Restore power and test fixture.
*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
RL5181
ASSEMBLY & INSTALLATION GUIDE