Installation Sheet

ASSEMBLY INSTRUCTIONS
A
B
C
D
E
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Carefully remove the mounting plate (B) from the back plate(E) by removing
side screws(D).
2. Secure the mounting plate (B) to the outlet box in your wall using the two
mounting screws(C).
3. Attach the ground wire from the fixture to the ground wire from the building
using the provided wire nut(A).
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
PROPERLY GROUNDED.
4. Attach the common wire (ribbed, no words) from the fixture to the white wire
from the building using the provided wire nut(A).
5. Attach the hot wire (smooth, with words) from the fixture to the black wire from
the building with the provided wire nut(A).
6. Secure each connection by tightening and then checking that no wires can be
pulled out.
IT IS IMPERATIVE THAT YOU NOT MIX THESE WIRES. OR SAFETY WILL
BE COMPROMISED.
7. Carefully tuck the wires inside the outlet box.
8. Secure back plate(E) onto mounting plate (B) by using side screws(D).
9. Insert bulb (not included) into socket.
10. Installation is complete, turn on power at fuse or circuit breaker.
DRY
Architectural Wall Sconce
Item # S20