Installation Sheet

WET

1. Carefully remove all parts from the carton.

2. Remove mounting plate (A) from fixture base (D) by removing base screws (C) in

counter-clockwise direction.

3. Remove lantern box (G) from fixture base (D) by removing bolts (H) in counter-clockwise

direction.

4. Remove tabs (E) by loosening set screws (F), insert glass panels (I) & (J) to the frame of lantern

box (G) and secure by placing tabs (E) to the glass panels (I) & (J) and tighten with set screws (F).

5. Insert light bulb into socket.

6. Replace lantern box (G) to fixture base (D) and secure with bolts (H).

7. Affix mounting plate (A) to wall outlet box and secure with mounting screws (B).

8. Gently pull the wires from the wall outle and allow the wires to hang. Thread the wires

through the center hole in mounting plate (A).

9. Attach ground (green) wire to ground wire from wall outlet box (usually green or copper

in color ), fasten together with a plastic wire connector. Tightly wrap the wire connector

with electrical tape. so the end of the connector is sealed. IT IS IMPERATIVE THAT THE

OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.

10. Connect neutral (white ) fixture wire coming from fixture base to neutral (usually white )

outlet wire. Fasten both wires together with a plastic wire connector and tightly wrap the

wire connector with electrical tape.

11. Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are

left outside the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS

OTHERWISE SAFETY WILL BE COMPROMISED.

12. Attach fixture base (D) with lantern box (G) to mounting plate (A) and secure by inserting base

screws (C).

13. INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS AND/OR IN WET LOCATION:

a. Mounting surface should be clean, dry, flat and 1/4" larger than canopy/fixture base on

all sides. Any gaps between the mounting surface and fixture base exceeding 3/16" should be

corrected as required.

b. With silicone (ex. GE-108) caulking compound, caulk completely around where back of

canopy/fixture base meets the wall surface to prevent water from seeping into outlet box.

TO AVOID WATER ENTERING THE FIXTURE BASE FROM THE SIDE OF FIXTURE, THIS

FIXTURE MUST BE MOUNTED ABOVE 1.2M (4 FT) FROM GROUND.

*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.

ASSEMBLY INSTRUCTIONS

Halle Small Wall Lantern

Item # S 2190

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED

ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.