Installation Sheet
1. Carefully remove all parts from the box.
2. Remove the lantern (I) from the fixture body (G) by loosening the thumbscrews (H).
3. Remove the mounting plate (C) from the fixture body (G) by unscrewing the side screws (F).
4. Put the mounting plate (C) on the wall, mark the anchor holes position with pencil
(not included). Drill holes on the wall and insert the anchors (A) into the holes.
5. Install the mounting plate (C) to the junction box and secure with the mounting screws (E) ,
then secure the wood screws (D) into the anchors (A).
6. Wrap the fixture ground wire to the green ground screw on the mounting plate (C) and
secure, then connect to ground wire in the junction box using wire nut (B).
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
7. Connect the fixture white wire to the neutral wire in the junction box using the wire nut (B).
8. Connect the fixture black wire to the hot wire in the junction box using the wire nut (B).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL
BE COMPROMISED.
9. Install the fixture body (G) to the mounting plate (C) and secure with the side screws (F).
10. Insert bulb (not included) into the socket.
11. Remove the metal bars (J) from the lantern (I) by unscrewing the screws (K) .
12. Attach the glass panels (L), (M) and (N) to the lantern (I) and secure with the metal bars (J)
using the screws (K).
13. Install the lantern (I) to the fixture body (G) and secure with the thumbscrews (H).
14. With silicone caulking compound, caulk completely around where back of backplate meets
the wall surface to prevent water from seeping into the junction box.
15. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Halle Large Wall Lantern
Item# S 2192
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
ASSEMBLY INSTRUCTIONS
A
B
C
D
E
G F
H
J
K
M
L
N
I
US
L
I
D
S
E
T
M
WET
J
K