Installation Sheet

ASSEMBLY INSTRUCTIONS

Auray Medium Tail Sconce

Item # S 2435

DRY

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED

ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Carefully remove all parts from the carton.

2. Remove mounting plate (A) from base of light fixture (D) by removing set screw (E)

using wrench (C) provided.

3. Affix mounting plate (A) to wall outlet box with mounting screws (B) provided.

4. Attach ground (green or green/yellow) wire to ground wire from wall outlet box (usually

green or copper in color ), fasten together with a plastic wire connector. Tightly wrap the

wire connector with electrical tape. so the end of the connector is sealed. IT IS IMPERATIVE

THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.

5. Connect both neutral (white ) fixture wires coming from fixture base to neutral (usually white )

outlet wire. Fasten three wires together with a plastic wire connector and tightly wrap the

wire connector with electrical tape.

6. Repeat the same procedure with the hot (black) wires. Always make sure that no wire strands

lreeft outside the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS

OTHERWISE SAFETY WILL BE COMPROMISED.

7. Attach fixture base (D) to the affixed mounting plate (A) and secure with set screw (E). Tighten

with wrench (C).

8. Remove socket ring (H) from sokcet (F), attach shade (G) onto the socket (G) and secure with

socket ring (H).

9. Insert light bulb (not included) into the socket.

10. Restore power and test fixture. Installation is complete.

*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.